The improvements of the IMod are as follows: Integral, but removable non-slip buttpad (color matched to stock components)
- Rolled/angled buttpad toe with wide traction area. This will assist in running the stock high on shoulder, making the IMod system more user friendly when using web-gear and/or body armor.
- Improved lock paddle, making it easier to operate and making the contact surface non-slip when operating the lever.
- Removed most sharp edges that may cause snag points to web-gear or other vital equipment.
- Improved strength throughout construction of the stock chassis. This will provide maximum strength during Mortaring exercise or unexpected impact.
|Design||Removable rubber buttpad and storage compartments. A true Modular buttstock for the AR15/M16/M4 carbine series.|
|Construction||Impact and temperature resistant polymer, specially blended for Vltor. Metal components are either carbon steel or stainless steel (depending on the application)|
|Compatibility||Milspec IMods will only fit receiver extensions/buffer tubes with the outer diameter of 1.150 .|
|Weight - Nominal||Less than 9.4 oz. (with storage compartment and buttpad installed)|
Length: 6.250 (without buttpad)
|Color Finish||All stocks have a matte (anti-reflection/glare) finish. IMods are only available in the following colors: Black, Flat Dark Earth (Tan) and Foliage Green. Foliage Green is more of a grey green versus Olive Drab.|
Storage capacity: Each side compartment can hold at least two AAs or three lithium CR123 3-volt batteries. The internal diameter of each compartment is 0.685 .Sling mounting: All Modstocks, including the IMod will accept a push-button, quick detachable sling swivel or a conventional web sling, measuring up to 1.375 in width. .